Recent content by C2BDB

Can you not get to it from inside ? Thru the sparker hole ?

https://www.facebook.com/Headlightretrofits/

There is a company up here in Scotland called headlightretrofits I know they can fit the projector units to oem headlights they are on Facebook and seem to have a good reputation and do some high end cars also some questionable mods

The car was wet so it was hard to say for sure but the spot welds on the inner lip of the rear arch looked original and so did the ones in the chanel where the boot lid shuts into ? Boot floor looked ok too ? My guess is it wasn't undersealed well enough ? And run through many winters on the...

i have no idea where the car came from (dicksons of perth) had imported it but where its been since import i don't know i don't think its local to the area I've never seen it about before

It's just a small local dealer and no one was about and the car was unlocked ! And I assume they know which it's as cheap ? It also had paint work done on the front as the engine bay was covered in dust car was wet so couldn't get a proper look at the paint finish

Basically it's rotten and Iam sure you could poke your fingers through the bodywork! I opened the filler cap door and round the filler neck was bubbling with thick rust from the inner wing After owning a facelift a few years back it was quite concerning how rough it was for an 06 car

http://www.autotrader.co.uk/classified/advert/201410308605895/postcode/ka107bb/usedcars Anyone planning to travel to look at this car send me a pm and I will share my findings with you I went to see it as its local to me and I wouldn't want anyone wasting too much time traveling to see it I...

If you can get it back I may be able to repair it depending on damage ?

that looks familiar to the first one i repaired too

sounds like it unfortunately i can't find any better pictures of mine if you post a picture i could say yay or nae :) p.s I've fixed two

if it helps thats what my amuse looked like ?

i don't think you have anything to worry about . i have seen this on another forum on an ep3 i think its part of the casting / forming of the sump he gave it a light rub with some sand paper and the " cracks " have disappeared you could try the same for piece of mind tho ? bob :)

I know someone who got 3 points for having a tire fitted in the wrong direction, He had just put the wheels on the car after having them powder coated and the powder coating place got it wrong he never noiced , got stopped by the traffic for a routine stop check and they noticed it and he got...