Search results

you made 235?? :xaiweb6:

What power did you make in the end?

It will fit just remember to pad the strut

SPoon

Cheers Andy for letting me know. But was thinking, you're working too hard if you was still down there. hope this gets sorted out for you.

Sorry to hear that Andy.. Have you been down there since we last spoke?

I miss my Dc5

go K24, roughly the same price

Thanks Tom, appreciate all the hard work..

onyxaltezza on ClubRSX

so is it -Birdy- Full kit (front lip, sides, rear, winglets) myself - front and side Brophy - Front and rear

Anyone else.. Only auto source do the front lips for preface lift dc5's

I'll have a Pre-facelift Rep Mugen lip + side skirts.

I'm out.. will go with -Birdy- on Groupbuy

I'm ready whenever mate

If you still have the Oem ones one they look pretty fine sitting like that. i've decided to go do 17x7.5 Et45 on the front and 17x.8.5 Et48 on the back and roll the arch if needed for the Rota Torque all i need is to sell my Rota C10's.. The wife doesnt know i'm getting new wheels since shes...

Have your put your new wheels on? if its the purple ones i think they look ok! also where did you get your Mugen Lip?

I would have thought 17x8 ET45 would just fit fine without any rubbing or the need of rolling the arches. I'm on 17x7.5 Et45 and they sit fine.

cheers mate.. i wanted to get a set of work emotion kai but since they are ET60 not sure how it will fit.. so going for a set of rota Torque and sell my Rays Bronze Rota C10

Thought so.. Really wanted a set of wheels 17x8 and 17x9 but wasnt sure about the offset issue..