Code P1166 & P1167 After Changing Shifter Cables

gaza4

Advanced Member
Messages
426
Bit of a long story here...
I was changing out my shifter cables and while I was under the car the O2 sensor wire was getting in the way. I tried to unplug it but I couldn't get the right angle at it so I just left it and worked around it. Inside the car I unplugged pretty much everything behind/under the 12V socket since they were in the way of getting the cables in.

After the cables were installed I started up the car forgetting about the plugs by the 12V and had an EML. Shut the car off, plugged everything back in and still had EML.
Got an OBD reader and got P1166 & P1167 which is lambda related. I've since got back under the car and that O2 sensor I was pulling at seems fine.

New O2 sensors are pricey so I don't wanna waste time and money on one if there's something else that I done that would cause these codes. Any thoughts?
 

Granty1943

Member
Messages
18
Hi.
I had this once when I failed to reconnect the rubber hose from the rocker cover to the air box. I cleared the fault and it went away, Unfortunately I didn't check the code. I just plugged in the OBD and cleared it.
Regards.
 

Granty1943

Member
Messages
18
Hi.
I would be stuck now if this happened to me. If you're confident at self help there's plenty of info on this problem out there. Failing that it's a mechanic mate or Honda specialist.
Regards.
 
Top