Surface rust inner rear arches

JordanSuth

Advanced Member
Messages
225
If you have patience and a long arm you can wire brush or sand back from the rear speaker hole.

If not take the rear trim out and you'll find better access as you'll see from attached photo.

After that you want to cure the rust. I personally use aqua steel.

After that has dried you'll want a cavity wax. I used clear waxoyl because I feel if you spray it black you cant check back in the future to have a look easily.


Sent from my SM-G973F using Tapatalk
 

gaza4

Advanced Member
Messages
426
your in the same boat as me. if you remove the whole panel as jordan says you'll have better access. i managed to get a drill in there with some attachments to clean up as much as possible and then used Hamber Bilt Deox Gel to convert what was left.

the cavity in your second pic goes deeper then what you can see and is quiet difficult to get to. i stuck my phone in there on video mode and recorded to see what the situation was like as i was goin
 
Top