Recent content by Chelt_scene

I have. Havent had time to fit them yet. Waited about 4 months for them tho

I've had mine four years only just realised there was a storage hole to the right of the steering wheel. Found 2 locking wheel but keys 😂

I'm running hybrid racing fuel rail

Went 70mm rbc with 70mm hybrid racing throttle body.

Don't believe they do mate.

Can it not just be hard wired into an ignition wire? I.e sterio or lighter ?

I removed mine too and put my map sensor on the rbc. Blanked them using the hybrid racing blanks and then made a plate that I bolted over it. You'll have to zoom in.

I got my ones for my mugen spoiler from a local car spare place I think they're M6 not sure on thread pitch though.

Fitted my guages 👍 Just gotta bond the bottom and straighten the guages out with some 3m tape

Federal 595 Rsr 235/40/18 front 225/40/18 rear

15mm wider than oem

Mine are 8j et 40 so around 10mm different. You'll be fine as long as your super low

I had a spec 4 aren't they slip fit so you'll need the gasket that goes into the manifold which is a 3 bolt one and I used some sealant in the slip fit with a exhaust u clamp

Why don't you take the other out and take it to an engineering place or a bolt specialist place I did it when I needed some longer engine mount bolts I took it to a bolt place local to me called balls grinding and just bought some longer ones?

Does Paul not offer a base map option if your driving up to him?