fitted my injen today

[mikegsi]

and was suprised at how easy it was!!

took about 3 hours all in, that included a few fag breaks while i read the how to guide in detail!

bumper came off very easily, and went back on just as well.


impressed with the noise too, doesnt half roar when you flog it, but nice and quiet when driving normally!

money well spent (as long as her indoors doesnt see the receipt!!)

 

[T666YPR]

Well done Mike xthumbup

They do make a lovely racket in :xvtec:

How did you sus the water bottle?

 

[mikegsi]

managed to get a rubber gromit and sealed in it with some gasket sealant (oil and water resistant) for extra strength.

couldnt get the bottom bolt through though, try as i might, ended up using some of my best friends - tie wraps!!!

the top two bolts went in no bother, so i figured they would secure it, and the bottom tie wrapped one will just hold it in place, seems fine so far!

other than that it went very easily~!

 

[T666YPR]

I found that rubber bolt thing was tricky,didn't know when it was tight enough :?
It seems ok though.

 

[mikegsi]

to tighten that one up i threaded the nut on the end and used my spanner on that till it felt nice and tight, then took the nut off and put the kit in!

just waiting for the roads to quiten down then i'm off for a little play!!

 

[DP.]

i re-drilled the bottom hole in the bottle a little bit and i managed to get the bolt in ok