Haze on Carbon Fibre Help Please.

[RaspyNoise]

Haze on my Carbon Fibre like water has sat on it and it has gone in the clear resin coat. I do not have a buffing machine so good old elbow grease is the case here!

What products or compound do I use to get rid of the haze and then what product do I use to protect the carbon fibre from such haze again?

Thank you

 

[Crackfox]

I'd try warming it up with a hair dryer first.

Sent from my SM-G960F using Tapatalk

 

[RaspyNoise]

Ok never heard of that I will give that a try! Have you tried that before? It only happened since washing the car

 

[Crackfox]

If you haze fresh ckearcoat you can sometime warm up the water and it will evaporate and exit with the paint gases as they vent. I dont much about resin, but would assume if it's just water that has caused it, it may just be in the pores of the resin and may evaporate away.

Always start least abrasive, so a light heat non contact would be my first try. Baring in mind its baked to cure so shouldn't damage it unless you get one spot too hot. Then I'd try polish if that doesnt work. Then I'd think about working down through some sand paper grades.

Sent from my SM-G960F using Tapatalk