Mugen Header - Needing to replace donut gasket

[poeter]

Hi guys,

Probably a long shot to get an answer but I'm trying to fix an exhaust leak. Replaced the mugen cat with a magna flow cat because the mugen cat had a crack in the body.

However, I also need to replace the gasket which I'm not sure where to get. As far as I gathered, the collector is 60.5mm.


Will any generic donut gasket 60.5mm ID size do the job? I'm not sure if i need a specific OD size.

Thanks


Sent from my iPhone using Tapatalk

 

[Gordyitrdc5]

Take the gasket to a motor factors & ask if they got anything that's the same size & thickness

 

[beppe786]

i had this problem.. only place was tegwia had the right size

 

[poeter]

Thanks for the replies guys.

Beppe, which size did you buy from tegiwa?