SPC Rear Camber Arms

[robbyp]

Am fitting SPC rear camber arms and was wondering do any of you guys know what length i need to set them at fot -1 degree of camber?
Regards
Rob

 

[Dc5Dub07]

Proper 4 Wheel laser alignment would be needed to determine this..

 

[phil r]

Proper 4 Wheel laser alignment would be needed to determine this..

Yep totally agree not a diy job ,

 

[robbyp]

Fitted the camber arms plus camber bolts today, was just looking a rough idea to do for a day or two til i get my camber and toe sorted out by someone proper. but thanks anyway dudes

 

[timp]

measure the stock ones mate and then set the spc's to stock and then set both sides the same. Unless you are running very much lower than standard its not going to be too bad and if they are both the same at least the balance of the car will be ok. Then go and get them dialed in properly for the type of driving you wanna be doing.