Valve clearances

[bennn]

Hi guys.

May have been covered but can anyone give me the correct valve clearances for the K20A?

Cheers

Ben

 

[Mark_teg]

Just a few times.

http://www.itr-dc5.com/forum/index.php?/topic/13474-valve-clearance-question/

Or check the service manual.

 

[bennn]

Thanks mate.

I assume from the attached the correct gaps are 0.008-0.010 inlet and 0.010-0.012 for exhaust?

 

[coyote_dc5]

Yes, there the ones but only if you have OEM head still?

 

[bennn]

I'm hoping so! I've only just bought the car. I checked the engine number which is a K20A and the previous keeper of 11 years didn't mention a head replacement.

 

[Rom]

I done mine to the lowest of the measurements listed in the manual. Because I like my gaps tight

 

[CaLi]

Thanks mate.

I assume from the attached the correct gaps are 0.008-0.010 inlet and 0.010-0.012 for exhaust?

Slight difference on exhaust but i have got them down as
0.008"-0.010" intake (0.20mm-0.25mm)
0.011"-0.013" exhaust.(0.28mm-0.33mm)

 

[Shortstuff]

I done mine to the lowest of the measurements listed in the manual. Because I like my gaps tight

Everyone lights a tight.... cat

 

[C&S Evo7]

i set them at .008" inlet and .010" exhaust , using a go/no go system with feeler blades