Recent content by DC5Jack

Cheers mate, guess I'm on the look out for a new drivers side seat rail then

Does anybody know if the driver and passenger seat rails are interchangeable? My drivers seat is flopping about on the rails but the passenger side is rock solid. Just wondered if I can change them over or if they are side specific Jack

Cheers mate. I'll keep my eye out for a second hand pair but I'm not paying £300 for 2 bits of plastic. I might pick up a set of the climair ones as they're reasonably priced. I cant believe it was the passenger side one was the one to come off. The drivers side one has been loose and...

So my passenger side wind deflector has decided to part company with my teg in the wind today. Does anybody know where I can get a replacement set or has anybody got a set for sale? Is anybody running a set of the climair ones? What are they like? Jack

If it was me I'd stick a Wavetrac LSD in there. They are a hell of a lot better than the stock diffs. They seem to have shot up in price since I got mine installed, which is a shame

On mine there was mainly noise & vibrations when on left hand turns. Especially bad when coming off turnings on the motorway. I had my box stripped down and inspected by Tdi, when it was in for other works. Had them stuff a wavetrac & new bearings in there while they had it apart Jack

When my diff was on it's way out it started making some awful noises especially when off throttle and decelerating. The diff input bearings were also knackered and needed changing. My teg had only done about 70k when I had to change the diff. So I don't know if that's something you want to...

DC5's turn heads even in fairly standard trim, but a good set of wheels never hurts. I've heard plenty of people talk about my car without releasing I was the owner. Best one was two old boys talking about how good it looked & sounded while i was standing right next to them.

Had the same problem with mine. Turns out the fuel level sender had fallen apart and was floating around in the tank. The garage fished it out and put it back together and it's worked ever since and that was about 5 years ago Jack

Said this a few times on here. Check the wiring on the ballasts. The wires had come loose on mine. As soon as they were reseated the lights worked properly. Did this about 4 years ago and I've never had a problem since. Easiest was is your whip the bumper and lights out to do this Jack

Happened to mine a few years ago and they stopped working right as I pulled into the MOT bay. Turns out it was wiring on the actual plugs for the ballasts. Reseated the pins and added some tape for security and they've been fine ever since. That was about 4 years ago now. Jack

I had a similar problem a few years ago but mine was on left hand bends. Turned out to be worn out differential bearings. Same as you it was fine everywhere else apart from in fast left hand bends it would make an awful annoying vibration. My actual diff was badly worn as well and took the...

Having the Teg slip off the jack. Thankfully it wasn't jacked up much and didn't cause any damage. Learned my lesson to check that the jack was properly placed before jacking it up again

The car right before my teg was a cosmic grey final edition EP3. It was a very good, clean and low mileage car till it was written off

Pulling back the carpet is very easy. You have pop off the trim on the side and the sills. First pull off the sill trim it's only held on with a 3 or 4 clips. Then pull off the side trim where the flare would go, again only held on with 2 clips. Pop off the rubber door seal around the bottom...