Recent content by tombakers

  1. T

    Oem exedy clutch enough for a mapped dc5

    Hi As above need a new clutch and was wondering of oem was enough for a 250hp dc5? Thanks
  2. T

    Recommended garage in mk for my dc5

    Thanks man Spoke to tgm earlier, you reckon I could drop the car there and leave it the whole week?
  3. T

    Recommended garage in mk for my dc5

    As above, anyone help atall? Need a clutch change doing Cheers
  4. T

    Dyno Charts!!

    I paid £300 but my ecu was already mapped for same mods minus the 3" exhaust on another car. I was very happy with the service and results/drive ability. They had just finished mapping a gallardo before mine went on the hub dyno. The dyno is in a controllers cell aswell for more consistent...
  5. T

    Dyno Charts!!

    I'm running a k100 They worked it out at around 257hp at fly. It did actually make another 8hp at the wheels that day but the dyno sets a correction factor to the figures as it was a cold day. (This is what I was told) this would of meant 265hp
  6. T

    Dyno Charts!!

    That is wheel horsepower aswell
  7. T

    Dyno Charts!!

    Gruppe m Rbc Thermal inlet gaskets Dc sports header 3" custom exhaust system
  8. T

    Lambda sensor 01

    36531 PRB A01 That is the part number, make sure you get a denso not some cheap crap. They go for as little as £100 I paid £120 2 weeks ago. Honda rob your money and sell you a denso and the Honda specialists monopolise on this and sell them for £185
  9. T

    O2 sensor (primary wideband)

    Where to buy one? Thanks
  10. T

    3" exhaust sounds

    Yeah I did wonder about the size of the silencers, bit on the small side. Was also considering a helmholtz resonator, they come standard on a s2000 and basically target a certain frequency of sound (the drone) and cancel it out by using the correct length pipe. It's a bit like blowing over a...
  11. T

    3" exhaust sounds

    Mine is droany, am going to make a few changes, hopefully will help. Work of art though, mandrel bends and tig welded Sounds lovely on tec.
  12. T

    Hunting idle and exhaust change question

    Sorted it (fingers crossed) Took the iacv off again and drilled out the screws on the electric motor part, that way you can spin the actual valve around whilst cleaning and lubing with wd40. There was a really sticky spot but now after cleaning and working it, it now moves freely. The only...
  13. T

    Hunting idle and exhaust change question

    Thanks rom, That's good yours sorted it self out. Where did you get the iacv from out of interest?
  14. T

    Hunting idle and exhaust change question

    Hi I have just fitted rbc to my car and since then the idle has been irratic. It's ok when first starting but once warmed up after a few mins the idle goes up and down (1.5 rpm to 2.5rpm) which is very annoying in traffic, especially with a loud 3" exhaust. I have tried cleaning the iacv and...
  15. T

    Trouble removing oem exhaust manifold

    Only just seen this this, yeah I did it on my back, if it was on a ramp it would of been much easier lol.
Top