Search results

I believe I know the answer to this question but I am hoping someone can shed some light and hopefully advise me how to resolve this. I recently decided to change my PS fluid as it was looking a bit murky. Rather than do a complete flush which I know would be the best thing to do I done it over...

This problem seems to have appeared out of the blue and I'm hoping someone on here can advise on the best route to sort it. I noticed some coolant dropping on to the ground the other day. At first I thought it may be a hose but it wasn't The coolant seems to be leaking from the top of the...

Hi. Does anyone on here run Evo 9 Enkeis? I have been offered a set as a swap for my standard alloys. Just wanting to get an idea how they would look on my DC5. I would be getting them refurbed in fiat 750f bronze pictured below so would be great if anyone could share photos of a white DC5...

Hi, I am wanting a bit of advice on how to tackle the above job. I started this last night and will be attempting to finish it in the next day or so. I have completely removed my Buddyclub coilovers and am replacing them with a set of standard shocks/lowering springs. The issue I am facing...

Alright guys. Pulled the rear shock apart and everything seemed good and dry but the bump stop bush looked a bit worse for wear as can be seen in the pictures. I contacted Buddyclub and they advised that this is a service item. I have since ordered it and will be fitting it tomorrow...

Hi guys. Been having an annoying knock from the rear DS of the Integra for a while now. Pulled the suspension out, compressed the spring and pulled it apart and the rubbers and various parts inside it were badly perished. Is there some sort of service kit available for this or should I simply...

Did you ever get to the bottom of this? I am having the same issue. Car is very tight apart from a slight 'clunk' over bumps coming from the back right hand side of the car. Similar to yourself, everything seems to be ok on the underside of the motor. How do I know if the top mounts are...

Hello. I changed the gearbox oil in my DC5 last night and I can only assume it is purely coincidence that as soon as letting the car off the ramp and starting it, it was running lumpy and struggling to idle. I did have a similar issue before this when I had an S90 TB on the car but ever since...

Thanks for the reply. I noticed a very slight split in my driver side front mount which I believe is a common problem. It isn't affecting the driving of the car as far as I can tell and I was looking at replacements and stumbled upon these. Had considered giving it a go and changing this one...

I was browsing through ebay and stumbled across these. They almost seem too good to be true if they were in fact a quality set of 4 engine mounts. They do however have a lot of good feedback with plenty of these items sold. Any thoughts or has anyone had these fitted...

Hello, I've been a member of the forum since I bought my 1st DC5 approx 4 months ago. I thought it was about time I introduced myself as I have been doing a bit of lurking and have found the forum very useful. I bought a 2003 C-Pack model DC5 and have just had it valeted so below are a few...

Anyone able to advise on a part number for the following trim? Just noticing now that this is missing! 🤔 I am referring to the trim below the steering wheel but i'm sure there should be trim over the port in the bottom left also?

Thanks for that man! Got sorted with the parts I needed and only £11.32 delivered to my door from Amayama. Cheers again.

Does anyone on here happen to know what the part number would be for the trip reset button on the clocks of a DC5? Mine is missing as well as a little glove box damper hinge which I have now sourced. (77508-S X0-000)

Hi. Sorry for hijacking this thread but this post seemed relevant to an issue I am having. The Dc5 i currently own has had the IACV blanked off. It suffers from the exact issue you mentioned where it idles at 500rpm until warmed up but is grand after that. Is there any way to resolve this...

Having a nightmare with a door lock actuator that I have just replaced! When reassembling the actuator I couldn't recall exactly how it went back together (stupid I know) Anyway got it assembled how I thought it was supposed to go and now the actuator works perfect but when I try and open the...

I'm not too sure to be honest......how would you check/resolve this? Since I've seen a few people reporting the same issue with a larger TB (particularly one as large as 76mm) I am going to revert to a standard TB as I would prefer it to drive a bit smoother. Would it be OK to stay with my...

Hmmmm that's good to hear that i'm not the only one to have experienced this but not so good that it wasn't resolved. Did you ever have it looked at? My car is going in for a service and valve clearances at a Honda Specialist so hopefully they can sort this issue.

Hi, I am just wondering if there is any straightforward way to adjust the sensitivity of the throttle on a DC5? My motor has the 76mm S90 throttle body on it so it may be related to this but the car seems to be very sensitive in regards to the throttle being on/off. It can make it jerky when...

Does anyone have any experience with S90 throttle bodies? To me it seems like the throttle position is either off or on with no inbetween. It can make the car sometimes a bit jerky especially with the upgraded clutch. I'm thinking there has to be a way to adjust the TPS or the sensitivity of...