Honda-atr
Advanced Member
- Messages
- 801
Today I wanted to get the full suspension done, so I ordered Hardrace droplinks, Energy suspension master bushing kit, Hardrace camber arms and a set of second hand Buddyclub Racing Spec dampers.
What started as a relaxed day installing parts changed when I tried to get the rear wheel sensor loose. All of a sudden I had a lot of copper wires in my hands and the sensor was broken. Completely stuck and I had to open my trickbox to get the broken parts out of the hub.
Ok, I have taken my loss and I have to get a new sensor. But when I tried to fit my rear left coilover it didn't fit through the hole :xaiweb6:
Measured the damper and the top is 70mm and the opening in the shell is also 70mm only it doesn't look like a round hole, more oval.
What can I do now to fit the coilovers. Do I have to try to get the shape round again in the body. I really don't have a clue what has caused this, but it's really strange.
I hope somebody can help me, I am a bit stuck here :xhuh: ...
What started as a relaxed day installing parts changed when I tried to get the rear wheel sensor loose. All of a sudden I had a lot of copper wires in my hands and the sensor was broken. Completely stuck and I had to open my trickbox to get the broken parts out of the hub.
Ok, I have taken my loss and I have to get a new sensor. But when I tried to fit my rear left coilover it didn't fit through the hole :xaiweb6:
Measured the damper and the top is 70mm and the opening in the shell is also 70mm only it doesn't look like a round hole, more oval.
What can I do now to fit the coilovers. Do I have to try to get the shape round again in the body. I really don't have a clue what has caused this, but it's really strange.
I hope somebody can help me, I am a bit stuck here :xhuh: ...