Recent content by Chris_EK4

Paid up :)

I was just wondering if TQX is any good/recommended for using in a K20? Its A5/Ford grade as I usually use when I put Castrol in so was just wondering what people's opinions are? Thanks

Mine pulled 244bhp on Eurospecs Dyno last week, Mapped my TDI South, AFR was straight as an arrow

Will Buddy Club rails for an ep3 fit a dc5? Thanks

Hi I'm supposed to be picking up a Kpro V3 tomorrow, its from an EP3, I know the wideband for the o2 sensor is different somehow, but can I use it in my DC5? I will be getting a remap as soon as it goes on, or will I have to/can I get the kpro chip/board taken out and re-soldered into my DC5...

Sorry dude not to mean to sound stupid but what's the RSX manual?

My car is idling at around 1700 rpm, its lost alot of power and the engine light is on with that code fault, we put a multimeter on the TPS and it read from the two earth points but got no signal from it with the throttle fully open, is this a broken TPS for sure or could it be a loom/connector...

I have a 3 inch solid fab...no silencers, its LOUD. On choke when starting it in the morning it will wake the dead (seriously its not for fussy neighbours)...thats with a decat and headers though

It read a fault code "power input low" on TPS, multimeter said no power signal from TPS no looks like its dead

I've fitted my RBC and TB, the car is idling around 1600-1900 rpm, running stock ecu at the moment, its feels more laggy and slower than before the RBC and I think it may be the TPS sensor as I just bolted it on not knowing it needed setting up on the new TB, its thrown the engine light on and...

Mines around 800-850, 1100 is too much for stock idle

I Know raising the comp ratio is pointless to a degree because of the fuel over here but I always use V-Power Nitro+ which is supposed to be 101 RON so surely that should do for stage 1/2 cams and a fresh oem DC5 comp ratio with the slight raise from the head gasket

I've decided that over the winter I will be doing an engine rebuild on my DC5, I was considering a JRSC but they are hard to find and would rather build the engine, but I am debating cams in the process, I spoke to Hond-R and they recommended Drag Cartel stage 1 drop in cams, RDX injectors and a...

I'm doing an engine rebuild on my DC5 and I'm pondering between head gaskets, Its between Cosworth, Spoon and Mugen, The Mugen looks like the best 0.5mm thick and raises the comp .4 points to 11:7 (iirc), I will be running Buddy Club Stage 2 cams, would this be a good choice? Keeping internals...

Thanks guys :) I'm already following you beppe according to instagram! I'm keeping all options open may go cam route instead haven't decided yet!