Search results

looks good

Took a closer look at the debris, they are really tiny and thing, the picture is really deceiving. heres another picture of underneath.

Thanks for the reply mate, the the stuff sat in my sump isn't that big, it only looks really big in that zoomed picture they are around 0.5mm. When we where turning the engine we could hear that the big end bearings were really loose, and the 1st one had totally spun out. What do you think...

thanks mate i have already got that downloaded. Was curious where you think the shavings came from in the sump ? Do you think its something else other than the bearings

its got 100k which is mix of KM and Miles. ill get a photo of the crankshaft, crankshaft looks alright. do you have any idea how to pull of the oil pump ?

So got the bearings off... This is the 1st one you can see its worn Heres a picture of Number 4: This is number 2: And these are number 3:

This is all i can find, does anyone know if this is the same for the K20A ?

Also what size plastigauge do i need ? If i knew what tolerance was i could get the right plaster gauge

Hey everyone, As most of you know i sold my DC5, Now i got a JDM EP3 K20A, Bottom end started knocking few days ago at around 2-3k, so taking the bottom end off to see where the damage is... Hoping its just the big end shells, So far we have taken off the subframe, sump, will be removing the...

I tested them out, And overall - they are really good tires for the price you pay... They grip really good, take corners well, they grip like the Bridgestone RE070 which are double the price, but they run out really quickly... i had them on my car for 4000miles and they had basically gone...

I could get one imported for you, if your interested... Minus all the fee's the companies charge on top.

I got mine from here £6.50 http://www.ebay.co.uk/itm/181188211279?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2649

yeah i got the evo flat seated wheels nuts too

PROBLEM SOLVED: Basically the garage i got my wheel balancing done from initially never removed the old weights and tried to counter balance with putting more on, which caused the shaking (idiots)... So went to a proper garage paid £15 more than before but hey got it done properly... Lesson...

thanks yeah will be going to a different garage today

i have spigot rings will be going today to a different garage

yeah but i just got them balanced, going to go back to the garage and see if they did it properly

Okay so i fitted my new wheels and tyres on, got them all balanced; but my car was too low and it rubbed around corners (that was only the problem initially) so i fitted new tein springs which where a bit higher, and rubbing stopped, today i got my alignment done as it was out by loads and...

thats cheap

hey buddy i have a spare set, you can have for £5 including postage