Search results

Bring it back to your tuner and have them scale the TPS in software of ecu, that should sort it.

Can you post picture of all 4 spark plugs and take note of which cylinder each plug is from, It is unfortunate that a proper analysis was not carried out when a piston broke on first engine, could have saved all this hassle with having to replace a 2nd engine and now subsequently a 3rd engine.

I'm pretty sure it is a mapping issue, i've fixed this issue for customer's who were tuned elsewhere previously

Have a read http://www.superstreetonline.com/techarticles/sstp_1002_k_series_intake_manifold_shootout/viewall.html

Remove the vtc solenoid and clean the filter screens.

Yes as the harness is designed for the Euro r's loom.

I'll get you a price but you would need to confirm wiring is the same between your model and euro r

I have mapped a couple of Euro R Accords 2003/2004 the wiring is probably similar in which case you can run a Hondata Kpro ecu along side standard ecu with a specially made harness. Let me know if you need a contact to purchase ecu and harness from.

Yep louder than N1. They do come with a bolt in silencer but that will be a hindrance to power when fitted.

3" catback on the k20 engine's are worthwhile. The Skunk2 catbacks are very good and the 76mm would be ideal for your engine. Just be warned though they are really loud!

@ Wayne & Dotty Noticed neither of your dyno sheet's are displaying "shootout mode" not sure why your tuner hasn't put the dyno in shootout mode??? When the dyno is not in "shootout mode" rotating inertia and ramp rates are not locked out so they can be altered by the operator to let's say...

It can be a number of things some times related to a wiring issue, cam sensor, VTC oil control solenoid and even in some cases it has been reported a fault within ecu. The VSS been off is due to the mph converter.

x2, fuelling is only a very small part of tuning these engine's

Good stuff, there a decent intake xthumbup

The bracket which bolts onto engine and mount is upside down

On average a DC5 with aftermarket exhaust and intake with stock ecu will make in the region of 210-220bhp and 150-ish Ftlb's torque on the Dyno Dynamics ran in shootout mode.

You can get a built k24 short block from a company called ERL in the States for roughly 2200-2500 pounds that's fully Blueprinted. If you know anyone working for a shipping company it's not that hard to get the short block back here for reasonable money. With a k20 head you would be looking at a...

Your sig says it all!! :xgrin: You'll enjoy the extra torque xthumbup

If you have Kpro then dry shot is what you want. Anything more than a 70shot and you'll need bigger injectors. RDX 410cc injectors are a good choice for the higher hp nos kits. Installation is pretty simple especially with the dry kits as there is no tapping fuel lines. With Kpro you can wire...